Dy-Mark Zinc Guard High Temp

• Designed to withstand temperatures up to 650 degrees
• Silicone based formula
• Matt black finish
• No primer required

Directions For Use

• Suitable Surfaces:
  Metal surfaces subject to extreme heat. Suitable for application on the exterior surfaces only. No primer is required.
• Ideal Application Temperature:
  Between 10°C and 30°C. Avoid use in windy conditions. Spray outside or in a well-ventilated area away from fire and heaters.
• Before Spraying:
  Surface should be clean, dry and free from contaminants such as rust, oil, grease, dirt and salt. Wipe surface with Mineral Turps or General Purpose Thinner. Thoroughly sand new metal and lightly sand previously painted and glossy surfaces to ensure maximum adhesion. Remove loose rust and flaking paint with a wire brush, scraper or mechanical sander. For best results, always remove rust back to bare metal. Primers should not be used as they will fail at high temperatures.
• Application:
  Before spraying, cover surrounding areas to protect from overspray. Shake can for at least 45 seconds AFTER the mixing ball begins to rattle.
  Shake the can occasionally during use. Hold the can upright approximately 20-25cm from the surface. Spray with a smooth sweeping motion. To prevent paint from sagging, apply several light mist coats rather than one heavy coat. Adjust nozzle to achieve desired spray pattern. Use horizontal setting to spray up and down and the vertical setting to spray left to right. Test spray first on a small inconspicuous area to ensure surface compatibility and finish suitability.
• Drying Time:
  Touch dry in 20 minutes (25°C).
  Recoat after 1 hour.
  Drying will be slower in cold and humid conditions, in the absence of ventilation or where heavy film build is applied. Note: Full cure is achieved
  by the heat generated during normal operation or by baking for 30 minutes at 250-300°C.
• Coverage: Approximately 2m2per can (depending on the surface and amount of overspray).